Eclipse Combustion F8000 Series Service/ Instructions d'exploitation télécharger pdf (Page 21)

2-7

C. FINAL ADJUSTMENTS

WARNING

FAILURE TO PROPERLY ADJUST EQUIPMENT MAY RESULT IN UNSAFE OPERATING

CONDITIONS FOR THE WHEELCHAIR OCCUPANT AND ATTENDANT.

1. FLOOR LEVEL TRAVEL LIMIT SETTING

The floor level travel limit setting is set at the factory for maximum travel. Follow this procedure

for checking and setting the platform travel limit at the proper vehicle floor level.

a. Deploy the lift.

b. Raise platform to the proper vehicle floor level and measure the distance between it and

the top platform surface. The floor level travel limit must be set so that the top platform

surface is between 1" and 1.6" above the vehicle floor. Proceed with the following

adjustment if distance is incorrect.

NOTE: Do not attempt to adjust bridgeplate until the travel limit has been set.

c. Provide support to the lift platform after raising platform.

d. Gain access to underside of platform.

e. Refer to Figure [2-5]. Loosen lock-nut from against trunion.

CARRIAGE

ASSEMBLY

LIFTING FRAME

ASSEMBLY

LOCK-NUT

PISTON

SHAFT

TRUNION

INSERT 3/8"

HEX KEY

ROTATE TRUNION CLOCKWISE TO

DECREASE TRAVEL LIMIT SETTING,

OR COUNTER-CLOCKWISE TO

INCREASE TRAVEL LIMIT SETTING

FIGURE [2-5]: TRAVEL LIMIT ADJUSTMENT

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 76 77

Pas de commentaire

Eclipse Combustion F8000 Series Service/ Instructions d'exploitation Page 21